
浏览全部资源
扫码关注微信
青岛征和工业股份有限公司,青岛 266700
金丽君,女,1975年生,山东青岛人,青岛征和工业股份有限公司技术中心总工程师,正高级工程师,青岛市拔尖人才;主要研究方向为链传动技术与应用;961429899@qq.com。
收稿:2026-05-22,
修回:2026-08-01,
录用:2026-08-03,
网络首发:2026-11-20,
移动端阅览
金丽君,于资江,戴龙杰.大规格大功率船舶用发动机传动链条疲劳特性研究[J].机械传动,XXXX,XX(XX):1-7.
Jin Lijun,Yu Zijiang,Dai Longjie.Fatigue characteristic analysis of large-size timing chain[J].Journal of Mechanical Transmission,XXXX,XX(XX):1-7.
目的
2
船舶发动机二次力矩补偿器专用大规格滚子链传动系统的传动精度与长周期服役可靠性的相关研究匮乏,为提高大功率船舶用发动机传动链条的疲劳特性,建立了精准的疲劳特性仿真方法并研究其疲劳性能,以期为大功率船舶用发动机传动链条的工程化应用提供技术支撑。
方法
2
基于多体动力学理论,利用RecurDyn软件建立传动链系统多体动力学模型,开展动力学仿真,以获取链条受力、运动轨迹及传动误差规律;采用AnsysWorkbench软件及Miner线性累积损伤理论,建立疲劳仿真模型,预测疲劳寿命并识别失效薄弱环节;搭建疲劳试验平台,开展升降法疲劳试验,对比仿真与试验数据验证模型准确性。
结果
2
结果表明,链条拉力动力学仿真与理论计算误差约9.52%,疲劳特性仿真与试验数据误差为9.75%,两项误差均不超过10%,且失效模式及失效部位完全一致。所建立的多体动力学模型与疲劳仿真模型具备高准确性与可靠性,可精准实现大规格传动链疲劳特性预测。
Objective
2
Studies on the transmission accuracy and long-term service reliability of the large-pitch roller chain transmission system dedicated to the secondary moment compensator of marine engines were scarce. To improve the fatigue characteristics of the transmission chain for high-power marine engines
an accurate simulation method for fatigue characteristics was established
and the fatigue performance of the chain was investigated
so as to provide technical support for the engineering application of such transmission chains in high-power marine engines.
Methods
2
Based on multibody dynamics theory
a multibody dynamics model of the drive chain system is established using RecurDyn software
and dynamic simulations are conducted to obtain the force
motion trajectory
and transmission error patterns of the chain. Additionally
a fatigue simulation model is created using Ansys Workbench software in conjunction with Miner’s linear cumulative damage theory to predict fatigue life and identify weak points of failure. A fatigue testing platform is also constructed to perform fatigue tests using the rising and lowering method
comparing simulation and experimental data to verify the accuracy of the model.
Results
2
The results indicate that the error between the dynamic simulation of chain tension and theoretical calculations is approximately 9.52%
while the error between fatigue characteristic simulations and experimental data is 9.75%
with both errors being≤10%
and the failure modes and locations are completely consistent. The established multibody dynamics model and fatigue simulation model demonstrate high accuracy and reliability
enabling precise prediction of the fatigue characteristics of large-scale drive chains.
黄泽好 , 罗福平 , 邢志斌 , 等 . 发动机活塞敲击下的整机动力学响应分析及优化 [J]. 噪声与振动控制 , 2024 , 44 ( 6 ): 224 - 229 .
Huang Zehao , Luo Fuping , Xing Zhibin , et al . Analysis and optimization of engine dynamic response under piston slap [J]. Noise and Vibration Control , 2024 , 44 ( 6 ): 224 - 229 .
李存志 , 付振明 , 王琛 , 等 . 刚性链链轮齿形结构创新设计研究 [J]. 制造技术与机床 , 2025 ( 6 ): 136 - 142 .
Li Cunzhi , Fu Zhenming , Wang Chen , et al . Research on innovative design of rigid chain sprocket tooth profile structure [J]. Manufacturing Technology & Machine Tool , 2025 ( 6 ): 136 - 142 .
苏阳 , 周瑞平 , 王正兴 , 等 . 大型柴油机滚子链传动系统建模方法及动力学特性研究 [J]. 内燃机 , 2017 , 33 ( 1 ): 1 - 5 .
Su Yang , Zhou Ruiping , Wang Zhengxing , et al . Modeling method and dynamics simulation analysis about roller chain drive system of large diesel engine [J]. Internal Combustion Engines , 2017 , 33 ( 1 ): 1 - 5 .
陈颖 , 伍勇 , 柳玉聪 , 等 . 大功率船用柴油机凸轮轴和齿轮系对曲轴扭振特性的影响研究 [J]. 内燃机 , 2025 , 41 ( 6 ): 47 - 53 .
Chen Ying , Wu Yong , Liu Yucong , et al . Investigation into the effects of the camshaft and gear train on the torsional vibration of the crankshaft in a high-power marine diesel engine [J]. Internal Combustion Engines , 2025 , 41 ( 6 ): 47 - 53 .
Saito R , Noda N A , Sano Y , et al . Fatigue strength analysis and fatigue damage evaluation of roller chain [J]. Metals , 2018 , 8 ( 10 ): 847 .
Jones J , Childs I . Implementation of a thorough treatment of chain out-of-plane (OPB) bending fatigue with chainwheel interaction [C]// Proceedings of the 2022 ASME 41st International Conference on Ocean, Offshore and Arctic Engineering , Hamburg : ASME , 2022 : V002T02A053 .
Witaszek K , Stanik Z . Evaluation of timing chain quality and its effect on timing system operation [J]. Transport Problems , 2024 , 19 ( 4 ): 95 - 108 .
刘美淇 . 叉车用高强度板式链疲劳特性研究 [D]. 长春 : 吉林大学 , 2025 : 35 - 36 .
Liu Meiqi . Study on fatigue characteristics of high strength plate chain for forklift truck [D]. Changchun : Jilin University , 2025 : 35 - 36 .
朱正中 , 邢方方 . 刮板输送机链条张力监测理论及方法研究 [J]. 煤矿开采 , 2015 ( 1 ): 48 - 50 .
Zhu Zhengzhong , Xing Fangfang . Chain tension monitoring theory and method of scraper conveyer [J]. Coal Mining Technology , 2015 ( 1 ): 48 - 50 .
孟繁忠 . 链传动技术手册 [M]. 北京 : 机械工业出版社 , 2016 : 896 .
Meng Fanzhong . Technology handbook of chain transmission [M]. Beijing : China Machine Press , 2016 : 896 .
廖鼎 , 朱顺鹏 , 牛晓鹏 , 等 . 机械结构概率疲劳研究:现状及展望 [J]. 机械工程学报 , 2025 , 61 ( 8 ): 47 - 74 .
Liao Ding , Zhu Shunpeng , Niu Xiaopeng , et al . Probabilistic fatigue research of mechanical structures:state-of-the-art and future trends [J]. Journal of Mechanical Engineering , 2025 , 61 ( 8 ): 47 - 74 .
轩福贞 , 朱明亮 , 王国彪 . 结构疲劳百年研究的回顾与展望 [J]. 机械工程学报 , 2021 , 57 ( 6 ): 26 - 51 .
Xuan Fuzhen , Zhu Mingliang , Wang Guobiao . Retrospect and prospect on century-long research of structural fatigue [J]. Journal of Mechanical Engineering , 2021 , 57 ( 6 ): 26 - 51 .
刘伟 , 孙丹 , 赵欢 , 等 . 基于Miner线性累积损伤理论的刷式密封疲劳寿命数值研究 [J]. 润滑与密封 , 2023 , 48 ( 8 ): 48 - 55 .
Liu Wei , Sun Dan , Zhao Huan , et al . Numerical study on fatigue life of brush seal based on Miner’s linear cumulative damage theory [J]. Lubrication Engineering , 2023 , 48 ( 8 ): 48 - 55 .
GB/T 20736—2025 传动用精密滚子链和板式链疲劳试验方法 [S].
GB/T 20736—2025 . Fatigue test method for transmission precision roller chains and leaf chains [S].
李扬 , 刘怀举 , 魏沛堂 , 等 . 基于Monte-Carlo模拟的小样本下齿轮疲劳极限计算方法及软件开发 [J]. 中国机械工程 , 2023 , 34 ( 2 ): 185 - 192 .
Li Yang , Liu Huaiju , Wei Peitang , et al . Calculation method and software development of gear fatigue strength under small samples based on Monte-Carlo simulation [J]. China Mechanical Engineering , 2023 , 34 ( 2 ): 185 - 192 .
刘潇然 , 孙秦 , 梁珂 . 工程P-S-N曲线的小子样预测方法研究 [J]. 西北工业大学学报 , 2018 , 36 ( 5 ): 831 - 838 .
Liu Xiaoran , Sun Qin , Liang Ke . A small sample prediction method for engineering P-S-N curve [J]. Journal of Northwestern Polytechnical University , 2018 , 36 ( 5 ): 831 - 838 .
0
浏览量
0
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621