某电驱动桥主减速器振动噪声特性仿真与试验研究

崔玥; 田韶鹏; 邹琳; 王新强

doi:10.16578/j.issn.1004.2539.2023.11.013

您当前的位置：

首页 >

文章列表页 >

某电驱动桥主减速器振动噪声特性仿真与试验研究

试验分析 | 更新时间：2023-12-01

- 某电驱动桥主减速器振动噪声特性仿真与试验研究
- Simulation and Experimental Study on Vibration and Noise Characteristics of the Main Reducer of an Electric Drive Axle
- 机械传动 2023年47卷第11期页码：86-93
- 作者机构：
  
  1.武汉理工大学汽车工程学院，湖北武汉 430070
  2.武汉理工大学机电工程学院，湖北武汉 430070
- 作者简介：
  
  崔玥(1997— )，女，湖北武汉人，硕士研究生；研究方向为新能源汽车动力系统、汽车零部件及NVH；842503677@qq.com。
  田韶鹏(1974— )，男，河南南阳人，博士，教授；研究方向为新能源汽车动力系统、智能电动平台；tianshp@whut.edu.cn。
- 基金信息：
  
  面向多场景的模块化电驱动平台技术研究及应用(桂科AA22068063);广西创新驱动发展专项资金项目(桂科AA19182003);柳州市科学技术局项目(2017AA10102)
- DOI：10.16578/j.issn.1004.2539.2023.11.013
  中图分类号：
- 纸质出版日期：2023-11-15，
  
  收稿日期：2022-09-15，
扫描看全文
崔玥,田韶鹏,邹琳等.某电驱动桥主减速器振动噪声特性仿真与试验研究[J].机械传动,2023,47(11):86-93.

Cui Yue,Tian Shaopeng,Zou Lin,et al.Simulation and Experimental Study on Vibration and Noise Characteristics of the Main Reducer of an Electric Drive Axle[J].Journal of Mechanical Transmission,2023,47(11):86-93.
崔玥,田韶鹏,邹琳等.某电驱动桥主减速器振动噪声特性仿真与试验研究[J].机械传动,2023,47(11):86-93. DOI： 10.16578/j.issn.1004.2539.2023.11.013.

Cui Yue,Tian Shaopeng,Zou Lin,et al.Simulation and Experimental Study on Vibration and Noise Characteristics of the Main Reducer of an Electric Drive Axle[J].Journal of Mechanical Transmission,2023,47(11):86-93. DOI： 10.16578/j.issn.1004.2539.2023.11.013.

摘要

利用Adams软件建立了主减速器“二级斜齿轮副-转子-轴承”仿真模型，仿真结果显示，在0~3 000 r/min，噪声主要来源于系统的共振，且高速级齿轮副贡献量较大。此外，进行了主减速器振动试验和实车噪声试验，结果表明，当输入转速为2 138.67 r/min时，主减速器的噪声值激增最为明显，与此相对应的齿轮副啮合频率为605.96 Hz，验证了仿真结果。最后，研究了轴承支承刚度对共振转速分布的影响，并提出系统结构刚度的优化措施。优化结果表明，在1 400~2 200 r/min转速带，振动幅值显著减小，共振转速向高转速偏移。试验结果与仿真分析结果相对误差均小于5%，证明了Adams仿真结果的正确性和优化措施的有效性，为缩短电驱动桥主减速器开发周期、节省研发成本提供了参考。

Abstract

In this study

a simulation model of the two-stage helical gear pair-rotor-bearing of the main reducer is developed by Adams software. The simulation results show that the noise mainly comes from the resonance of the system and the contribution of the high-speed gear pair is large when the speed is in the range of 0~3 000 r/min. Furthermore

the vibration test of the main reducer and the real vehicle noise test are also conducted. The test results show that the noise of the main reducer increases obviously when the input speed is 2 138.67 r/min

and the corresponding meshing frequency of the gear pair is 605.96 Hz

verifying the simulation results. Finally

the effect of bearing stiffness on the resonance speed distribution is studied

and the optimization measures of the structural stiffness of the system are proposed. After optimization

the vibration amplitude decreases significantly when the speed is in the range of 1 400~2 200 r/min

and the resonance speed shifts to a higher speed. The relative errors between the test results and simulation analysis results are less than 5%

which verifies the Adams simulation results and the optimization measures

and provides some reference for shortening the development cycle of the electric drive axle main reducer and saving research and development costs.

关键词

电驱动桥齿轮-转子-轴承系统共振特性路试试验

Keywords

Electric drive axleGear-rotor-bearing systemResonance characteristicsRoad test

references

孙志凡.电动车减速器振动噪声动力学分析［D］.武汉：武汉理工大学，2020：9-10.

SUN Zhifan.Vibration noise and dynamic analysis of electric vehicle reducer［D］.Wuhan： Wuhan University of Technology，2020：9-10.

LIAO L，ZUO Y，MENG H，et al.Research on the technology of noise reduction in hybrid electric vehicle with composite materials［J］.Advances in Mechanical Engineering，2018，10（3）：168781401876691.

MILLITHALER P，DUPONT J B，OUISSE M，et al.Viscoelastic property tuning for reducing noise radiated by switched-reluctance machines［J］.Journal of Sound and Vibration，2017，407：191-208.

江洪，徐建锋，赖泽豪，等.变速器振动对纯电动汽车车内噪声的影响［J］.机械设计与制造，2015（1）：48-51.

JIANG Hong，XU Jianfeng，LAI Zehao，et al.Analysis of the gearbox vibration impact on noise inside pure electric vehicle［J］.Machinery Design & Manufacture，2015（1）：48-51.

于蓬，陈霏霏，章桐，等.集中驱动式纯电动车动力总成噪声特性分析［J］.机电一体化，2015，21（1）：7-12.

YU Peng，CHEN Feifei，ZHANG Tong，et al.Acoustic characteristic analysis of central driven power train of electric vehicle［J］.Mechatronics，2015，21（1）：7-12.

王瑞欣，杨超，李金峰，等.电动汽车高速齿轮的振动噪声分析方法研究［J］.机械传动，2019，43（4）：32-36.

WANG Ruixin，YANG Chao，LI Jinfeng，et al.Research of vibration and noise analysis method of high-speed gear for electric vehicle［J］.Journal of Mechanical Transmission，2019，43（4）：32-36.

蔡文奇.纯电动汽车两挡变速箱齿轮振动噪声仿真分析与优化设计［D］.长春：吉林大学，2019：57-58.

CAI Wenqi.Simulation analysis of gear vibration noise and optimization design of pure electric vehicle two-speed gearbox［D］.Changchun： Jilin University，2019：57-58.

KAHRAMAN A，SINGH R.Non-linear dynamics of a geared rotor-bearing system with multiple clearances［J］.Journal of Sound and Vibration，1991，144（3）：469-506.

ARAKERE N K，NATARAJ C.Numerical simulation of nonlinear spur-gear dynamics［C］//ASME Design Engineering Technical Conferences，1999：2987-2994.

LI C F，ZHOU S H，LIU J，et al.Coupled lateral-torsional-axial vibrations of a helical gear-rotor-bearing system［J］.Acta Mechanica Sinica，2014，30（5）：746-761.

FAKHFAKH H，BRUYÈRE J，VELEX P，et al.A torsional model of multi-stage gears influence of external excitations and tooth shape modifications［J］.Mechanics and Industry，2016，17（4）：413.

LIU J，ZHAO W，LIU W.Frequency and vibration characteristics of high-speed gear-rotor-bearing system with tooth root crack considering compound dynamic backlash［J］.Shock and Vibration，2019，2019：1-19.

ZHU H，CHEN W，ZHU R P，et al.Modelling and dynamic analysis of the spiral bevel gear-shaft-bearing-gearbox coupling system［J］.Mathematical Problems in Engineering，2019，2019：1-16.

WANG S，ZHU R P，FENG J.Study on load sharing behavior of coupling gear-rotor-bearing system of GTF aero-engine based on multi-support of rotors［J］.Mechanism and Machine Theory，2020，147（8）：103764.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

齿轮-转子-轴承系统复合故障振动特性研究

轻型商用车集成式电驱动桥试验台及方法研究