1.哈尔滨理工大学 机械动力工程学院, 黑龙江 哈尔滨 150080
2.哈尔滨工业大学 机电工程学院, 黑龙江 哈尔滨 150001
3.江苏盛安传动股份有限公司, 江苏 盐城 224015
刘文宇(1996— ),男,安徽阜阳人,在读硕士研究生;主要研究方向为齿轮动力学。
于广滨(1978— ),男,黑龙江哈尔滨人,博士生导师;主要研究方向为机械传动、齿轮动力学和数字化仿真技术。
扫 描 看 全 文
刘文宇,孙永国,于广滨等.随机扰动下考虑搅油阻力的齿轮动力特性分析[J].机械传动,2022,46(04):55-62.
Liu Wenyu,Sun Yongguo,Yu Guangbin,et al.Analysis of Gear Dynamic Characteristic of Oil Churning Resistance under Stochastic Disturbance[J].Journal of Mechanical Transmission,2022,46(04):55-62.
刘文宇,孙永国,于广滨等.随机扰动下考虑搅油阻力的齿轮动力特性分析[J].机械传动,2022,46(04):55-62. DOI: 10.16578/j.issn.1004.2539.2022.04.008.
Liu Wenyu,Sun Yongguo,Yu Guangbin,et al.Analysis of Gear Dynamic Characteristic of Oil Churning Resistance under Stochastic Disturbance[J].Journal of Mechanical Transmission,2022,46(04):55-62. DOI: 10.16578/j.issn.1004.2539.2022.04.008.
搅油润滑是齿轮系统一种重要的润滑方式,由于润滑油的黏弹性会使浸入其中的齿轮在高速运转时获得额外的阻力,且齿轮系统由于自激振动等因素,时刻存在一些不确定的扰动。因此,综合考虑啮合间隙、时变啮合刚度、传动误差、随机扰动以及搅油阻力等非线性因素,通过拉格朗日法建立了6自由度的直齿轮非线性动力学模型,运用龙格-库塔方法求解得到系统的分岔图、相图、Poincarè图、时间历程图和动态载荷系数(Dynamic load factor,DLF),综合分析对比了随机扰动下搅油阻力对齿轮系统动态特性的影响。结果表明,随机扰动会使系统的混沌特性发生变化,相图的表现尤为明显,轨迹形状不变,但周期性受到明显影响,周期运动转向准周期运动;在以随机扰动为正常工作状态的条件下,搅油阻力会使得系统提前进入混沌状态。
Oil churning lubrication is an important lubrication method of gear system. Considering the viscoelasticity of the lubricant oil will result in additional resistance upon gears immersed in the oil while running at high-speed,and the gear system can get disturbed at all times due to self-exciting vibration and other factors. Thus,considering the backlash,time-varying mesh stiffness,transmission error,stochastic disturbances,oil churning resistance and other nonlinear factors, compares and analyzes the influence of oil churning resistance upon dynamic characteristics of the gear system under stochastic disturbance by establishing a nonlinear dynamic model of straight gears with 6 degrees of freedom and using by Lagrange method using the bifurcation diagram,phase diagram,Poincarè diagram,time-history graph and dynamic load factors (DLF) obtained by the R-K method. The results show that stochastic disturbances can change the chaotic characteristics of the system,and its influence on the phase diagram is particularly obvious,the trajectory shape remains the same,but the periodicity is significantly affected and the periodic motion turns to quasi-periodic motion. When the condition of being under stochastic disturbances is considered as a normal working state,the oil churning resistance can make the system enter the chaotic state in advance.
非线性随机扰动搅油阻力分岔混沌
NonlinearStochastic disturbanceOil churning resistanceBifurcationChaos
HE S,CHO S,SINGH R.Prediction of dynamic friction forces in spur gears using alternate sliding friction formulations[J].Journal of Sound and Vibration,2008,309(3/4/5):843-851.
石建飞,苟向锋,朱凌云.计及摩擦的多状态啮合渐开线直齿轮系统动力学建模分析[J].西北工业大学学报,2020,38(2):401-411.
SHI Jianfei,GOU Xiangfeng,ZHU Lingyun.Dynamic modeling and analysis of involute spur gear transmission system considering friction and multi-state meshing conditions[J].Journal of Northwestern Polytechnical University,2020,38(2):401-411.
MBAREK A,HAMMAMI A,ALFONSO F D R,et al.Effect of load and meshing stiffness variation on modal properties of planetary gear[J].Applied Acoustics,2019,147:32-43.
尹桩,苟向锋,朱凌云.考虑齿面冲击及摩擦的单级齿轮系统动力学建模及分析[J].振动工程学报,2018,31(6):974-983.
YIN Zhuang,GOU Xiangfeng,ZHU Lingyun.Dynamic modeling and analysis of single-stage gear system considering tooth surface impact and friction[J].Journal of Vibration Engineering,2018,31(6):974-983.
HUANG K,YI Y,XIONG Y S,et al.Nonlinear dynamics analysis of high contact ratio gears system with multiple clearances[J].Journal of the Brazilian Society of Mechanical Sciences and Engineering,2020,42(4):69-76.
FARGERE R,VELEX P.Influence of clearances and thermal effects on the dynamic behavior of gear-hydrodynamic journal bearing systems[J].Journal of Vibration and Acoustics,2013,135(6):061014.
YI Y,HUANG K,XIONG Y S,et al.Nonlinear dynamic modelling and analysis for a spur gear system with time-varying pressure angle and gear backlash[J].Mechanical Systems and Signal Processing,2019,132:18-34.
刘杰,赵伟强,任望.具有动态侧隙的齿轮传动系统动力响应分析[J].振动.测试与诊断,2020,40(6):1184-1190.
LIU Jie,ZHAO Weiqiang,REN Wang.Dynamic response analysis of gear transmission system with dynamic backlash[J].Journal of Vibration,Measurement & Diagnosis,2020,40(6):1184-1190.
卢少波,靳宗向,康学忠.计及空间温度效应的齿轮系统动力学行为研究[J].振动与冲击,2017,36(12):163-168.
LU Shaobo,JIN Zongxiang,KANG Xuezhong.A study of the dynamic behavior of a gear system considering space temperature effec[J].Journal of Vibration and Shock,2017,36(12):163-168.
李小彭,潘五九,高建卓,等.结合面形貌特性对模态耦合不稳定系统的影响[J].机械工程学报,2017,53(5):116-127.
LI Xiaopeng,PAN Wujiu,GAO Jianzhuo,et al.Influence of surface topography characteristics on mode coupling instability system[J].Journal of Mechanical Engineering,2017,53(5):116-127.
陈奇,黄守武,张振,等.考虑摩擦因素的两圆柱体表面接触承载能力的分形模型研究[J].机械工程学报,2016,52(7):114-121.
CHEN Qi,HUANG Shouwu,ZHANG Zhen,et al.Research on fractal contact model for contact carrying capacity of two cylinders' surfaces considering friction factors[J].Journal of Mechanica Engineering,2016,52(7):114-121.
李小彭,徐金池,潘五九,等.含齿面分形啮合刚度的齿轮传动系统动力学[J].哈尔滨工业大学学报,2019,51(7):56-62.
LI Xiaopeng,XU Jinchi,PAN Wujiu,et al.Dynamics of gear transmission system with fractal meshing stiffness on tooth surface[J].Journal of Harbin Institute of Technology,2019,51(7):56-62.
郑光泽,杨航,郝涛,等.齿轮搅油功率损失与减速器传动效率分析[J].机械传动,2020,44(12):49-54.
ZHENG Guangze,YANG Hang,HAO Tao,et al.Analysis of gear oil churning power loss and transmission efficiency of reducer[J].Journal of Mechanical Transmission,2020,44(12):49-54.
郭栋,陈芳超,刘骄,等.齿轮副高速搅油阻力矩理论计算与试验研究[J].机械工程学报,2021,57(1):49-60.
GUO Dong,CHEN Fangchao,LIU Jiao,et al.Theoretical and experimental study of oil churning resistance torque of high-speed gear pair[J].Journal of Mechanical Engineering,2021,57(1):49-60.
王靖岳.随机扰动下齿轮传动系统的非线性动力学与故障辨识研究[D].沈阳:东北大学,2015:53-86.
WANG Jingyue.Research on nolinear dynamics and fault identification of gear transmission system with stochastic disturbance[D].Shenyang:Northeastern University,2015:53-86.
LEE C,LIN H H,OSWALD F B,et al.Influence of linear profile modification and loading conditions on the dynamic tooth load and stress of high-contact-ratio spur gears[J].Journal of Mechanical Design,1991,113(4):473-480.
0
浏览量
3
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构