1.青岛理工大学 机械与汽车工程学院, 山东 青岛 266520
李栋(1993— ),男,山东招远人,硕士研究生,研究方向为润滑理论。
刘晓玲(1972— ),女,山东青岛人,博士,教授,博士生导师,主要研究方向为润滑理论。
扫 描 看 全 文
李栋,刘晓玲,周江敏等.滚动直线导轨的弹流润滑数值分析[J].机械传动,XXXX,XX(XX):106-110.
Li Dong Liu Xiaoling Zhou Jiangmin Liu Fengqi.Numerical Analysis of Elastohydrodynamic Lubrication of Rolling Linear Guides[J].Journal of Mechanical Transmission,XXXX,XX(XX):106-110.
李栋,刘晓玲,周江敏等.滚动直线导轨的弹流润滑数值分析[J].机械传动,XXXX,XX(XX):106-110. DOI: 10.16578/j.issn.1004.2539.2019.11.019.
Li Dong Liu Xiaoling Zhou Jiangmin Liu Fengqi.Numerical Analysis of Elastohydrodynamic Lubrication of Rolling Linear Guides[J].Journal of Mechanical Transmission,XXXX,XX(XX):106-110. DOI: 10.16578/j.issn.1004.2539.2019.11.019.
为研究滚动直线导轨的润滑性能,对LG-45型滚动直线导轨进行了运动分析,建立了导轨副的弹流润滑模型,并对其润滑性能进行了研究,分析了不同接触角、滚珠直径、曲率比、润滑油参数下的油膜厚度,同时讨论了滚珠直径、接触角对导轨副润滑状态的影响。结果表明,在接触角增大时,油膜厚度减小;在滚珠直径增大时,油膜厚度增大;在曲率比增大时,油膜厚度增大,但增加的趋势减小;在相同工况下,润滑油黏度和黏压系数较大时,膜厚较大。在文中研究工况条件下,滚珠直径和接触角变化时不会改变导轨副的润滑状态。
In order to study the lubrication performance of rolling linear guides,based on the LG-45 rolling linear guides,the kinematics analysis is carried out. An elastohydrodynamic lubrication(EHL)model is established for the rolling linear guides,and its lubricating performance is investigated. The film thickness with various contact angle,ball diameter,load,curvature ratio and lubricant parameters is analyzed. Effects of the ball diameter and the contact angle on the lubrication state of the guide rail are discussed. The results show that the oil film thickness decreases when the contact angle increases. The oil film thickness increases with the ball diameter increasing. When the curvature ratio increases,the oil film thickness increases,but the increase trend becomes less. Under the same working condition,when the viscosity and viscosity-pressure coefficient of lubricating oil is large,the film is thicker. Variations in the ball diameter and the contact angle cannot change the lubrication state with parameters discussed.
滚动直线导轨 运动分析 油膜厚度 润滑状态
Rolling linear guidesKinematics analysisOil film thicknessLubrication state
许向荣.滚珠丝杠副直线导轨进给单元动态性能研究[D].济南:山东大学,2011:26-32.
姜大志,应强,孙俊兰.滚动直线导轨的受力分析与载荷计算[J].机床与液压,2008,4(4):270-272.
吴文喜,姜大志.滚动直线导轨副静刚度模型的研究[J].机械设计与制造,2009(5):135-137.
LI C M,FENG H T,YU Y M.The Design of dynamic friction measuring system of linear rolling guide[C].Proceedings of the 3rd International Conference on Mechanical Engineering and Mechanics,2009:445-451.
赵义鹏,梁医,冯虎田,等.滚动直线导轨副磨损特性和磨损机理试验研究[J].材料导报B:研究篇,2018,32(6):915-923.
张怡雯,欧屹,冯虎田,等.速度和供油量对滚动直线导轨副摩擦力的影响[J].润滑与密封,2017,42(3):119-123.
申明主,刘建龙,谷红宽.滚动直线导轨的最小油膜厚度与润滑脂的选择[J].石油商技,2016,34(1):28-31.
张朝辉,孙健利.滚动直线导轨的弹流润滑分析[J].机械设计,1997(9):27-29.
李林林.滚动直线导轨接触副的微观流体润滑及动力学特性研究[D].武汉:华中科技大学,2017:35-57.
范静锋,姜大志.滚动直线导轨承载区的运动分析[J].机械设计与制造,2008(9):193-194.
ROELANDS C J A.Correctional aspects of the viscosity-temperature-pressure relationship of lubricating oils[D].Delft:Technische Hogeschool Delft,1966:209-210.
DOWSON D,HIGGINSON G R.Elasto-hydrodynamic lubrication[M].Oxford:Pergamon,1977:8-31.
VENNER C H.Multilevel solution of the EHL line and point contact problems[D].Enschede:University of Twente,1991:929-942.
BRANDT A,LUBRECHT A.Multilevel matrix multiplication and fast solution of integral equations[J].Journal of Computational Physics,1990,90(2):348-370.
熊春华,王成彪,赵巍,等.润滑油粘度对缸套/活塞环摩擦学性能的影响[J].机械工程师,2011(6):9-11.
温诗铸,杨沛然.弹性流体动力润滑[M].北京:清华大学出版社,1992:29-36.
0
浏览量
2
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构