Analysis of Factors Affecting Lubrication Performance of Crankshaft Main Bearing Considering Thermal Effect

Shao Kang; Wang Guangdong; Bi Fengrong

doi:10.16578/j.issn.1004.2539.2022.10.018

您当前的位置：

首页 >

文章列表页 >

Analysis of Factors Affecting Lubrication Performance of Crankshaft Main Bearing Considering Thermal Effect

Test·Analysis | 更新时间：2022-11-05

- Analysis of Factors Affecting Lubrication Performance of Crankshaft Main Bearing Considering Thermal Effect
- Journal of Mechanical Transmission Vol. 46, Issue 10, Pages: 119-124(2022)
- 作者机构：
  
  1.天津大学内燃机燃烧学国家重点实验室，天津 300072
  2.陆军军事交通学院军事交通运输研究所，天津 300161
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2022.10.018
  CLC：
扫描看全文
邵康,王广东,毕凤荣.计入热效应的曲轴主轴承润滑性能影响因素分析[J].机械传动,2022,46(10):119-124.

Shao Kang,Wang Guangdong,Bi Fengrong.Analysis of Factors Affecting Lubrication Performance of Crankshaft Main Bearing Considering Thermal Effect[J].Journal of Mechanical Transmission,2022,46(10):119-124.
邵康,王广东,毕凤荣.计入热效应的曲轴主轴承润滑性能影响因素分析[J].机械传动,2022,46(10):119-124. DOI： 10.16578/j.issn.1004.2539.2022.10.018.

Shao Kang,Wang Guangdong,Bi Fengrong.Analysis of Factors Affecting Lubrication Performance of Crankshaft Main Bearing Considering Thermal Effect[J].Journal of Mechanical Transmission,2022,46(10):119-124. DOI： 10.16578/j.issn.1004.2539.2022.10.018.

摘要

针对曲轴主轴承润滑性能的影响因素，建立计入热效应的主轴承弹性流体动力润滑模型，模型将轴承外部载荷、轴承间隙和进油温度作为变量，分析了主轴承在不同变量下的最大油膜压力、最小油膜厚度、最高轴承温度和最大摩擦功率损失。结果表明，计入热效应对曲轴主轴承有较大影响，当轴承外部载荷增大时，轴承的最大油膜压力、最小油膜厚度和最大摩擦功率损失均会增大；当轴承间隙变小时，轴承的最大油膜压力减小，轴承温度升高；当进油温度增加，轴承最大油膜压力增大、最小油膜厚度减小、最大摩擦功率损失减小。

Abstract

In view of the factors affecting the lubrication performance of crankshaft main bearing, an elastohydrodynamic lubrication model of crankshaft main bearing, considering thermal effect, is established. The model takes the external load of bearing, bearing clearance and oil inlet temperature as variables to analyze the maximum oil film pressure, minimum oil film thickness, maximum bearing temperature and maximum friction power loss under different variables. The calculation results show that the thermal effect has a great influence on the crankshaft main bearing. When the external load of the bearing increases, the maximum oil film pressure, minimum oil film thickness and maximum friction power loss will increase; when the bearing clearance becomes smaller, the maximum oil film pressure decreases and the bearing temperature increases; when the oil inlet temperature increases, the maximum oil film pressure increases, the minimum oil film thickness decreases and the maximum friction power loss decreases.

关键词

热效应曲轴主轴承轴承间隙进油温度外部载荷

Keywords

Thermal effectCrankshaft main bearingBearing clearanceOil inlet temperatureExternal load

references

周玮，廖日东.高功率密度柴油机主轴承热弹流混合润滑分析［J］.内燃机学报，2016，34（4）：370-378.

ZHOU Wei，LIAO Ridong.Thermo-elasto-hydrodynamic mixed lubrication analysis of main bearings for high power-density diesel engine［J］.Transactions of CSICE，2016，34（4）：370-378.

LI B，SUN J，ZHU S Y，et al.Thermohydrodynamic lubrication analysis of misaligned journal bearing considering the axial movement of journal［J］.Tribology International，2019，135：397-407.

OZASA T，MAITANI K，FUJIMOTO Y，et al.Simplified estimation method of bearing friction for engines［J］.International Journal of Engine Research，2016，17（8）：886-896.

BI F R，SHAO K，LIU C W，et al.Analysis of thermos-elasto-hydrodynamic performance of journal misaligned engine main bearings［J］.Chinese Journal of Mechanical Engineering，2015（3）：511-520.

LORENZ N，OFFNER G，KNAUS O.Fast thermo-elasto-hydrodynamic modeling approach for mixed lubricated journal bearings in internal combustion engines［J］.ARCHIVE Proceedings of the Institution of Mechanical Engineers Part J Journal of Engineering Tribology 1994-1996 （Vols 208-210），2015，229（8）：962-976.

林建辉，王炳轩，魏立队.整机体下船舶柴油机主轴承热弹流体动力混合润滑研究［J］.大连海事大学学报，2020，46（4）：102-111.

LIN Jianhui，WANG Bingxuan，WEI Lidui.Research of thermal-elasto-hydrodynamic lubrication of main bearings of marine diesel engines based on whole engine block［J］.Journal of Dalian Maritime University，2020，46（4）：102-111.

杨靖，张纯标，刘凯敏，等.考虑非稳态传热的高速汽油机主轴承润滑分析［J］.车用发动机，2016（3）：40-46.

YANG Jing，ZHANG Chunbiao，LIU Kaimin，et al.Lubrication analysis of main bearing for high speed gasoline engine based on non-stationary heat transfer［J］.Vehicle Engine，2016（3）：40-46.

滕宪斌，张均东，叶伟强.基于热弹性流体动压润滑的柴油机曲轴主轴承润滑特性分析［J］.船舶工程，2016，38（4）：61-64.

TENG Xianbin，ZHANG Jundong，YE Weiqiang.Characteristic analysis of diesel engine main bearing lubrication based on thermo-elastic hydrodynamic pressure［J］.Ship Engineering，2016，38（4）：61-64.

KYRKOU M E，NIKOLAKOPOULOS P G.Simulation of thermo-hydrodynamic behavior of journal bearings，lubricating with commercial oils of different performance［J］.Simulation Modelling Practice and Theory，2020，104（1）：102128.

郎骥，杨建刚，曹浩，等.滑动轴承热效应分析及流场等效温度的合理确定［J］.润滑与密封，2012，37（10）：70-73.

LANG Ji，YANG Jian'gang，CAO Hao，et al.Thermal effect analysis and fluid field average temperature reasonable determination of journal bearing［J］.Lubrication Engineering，2012，37（10）：70-73.

虞祥松，向建华，左正兴.考虑热弹性效应的内燃机曲轴主轴承润滑性能研究［J］.润滑与密封，2012，37（10）：54-59.

YU Xiangsong，XIANG Jianhua，ZUO Zhengxing.Study on lubrication performances of crankshaft main bearing for internal combustion engine considering thermo-elastohydrodynamic effect［J］.Lubrication Engineering，2012，37（10）：54-59.

王家序，倪小康，韩彦峰，等.倾斜轴颈滑动轴承混合热弹流研究［J］.中南大学学报（自然科学版），2019，50（10）：2425-2434.

WANG Jiaxu，NI Xiaokang，HAN Yanfeng，et al.Mixed thermos-elasto-hydrodynamic lubrication investigation of misaligned journal bearings［J］.Journal of Central South University （Science and Technology），2019，50（10）：2425-2434.

杨帅，郭红，张泽斌.热效应对径向浮环轴承最小油膜厚度及稳定性影响研究［J］.振动与冲击，2020，39（18）：215-222.

YANG Shuai，GUO Hong，ZHANG Zebin.Thermal effect on the minimum film thickness and stability for a journal floating ring bearing［J］.Journal of Vibration and Shock，2020，39（18）：215-222.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on the Effect of Water Pollution in Lubricant on Gear Thermal Elastohydrodynamic Lubrication Characteristic

Analysis of Thermal Elastohydrodynamic Lubrication of Modified Gear Rack Transmission

Influence of Microscopic Particle Flow on Thermal Elastohydrodynamic Lubrication of Spur Gear

Related Author

No data

Related Institution

Wuxi Transportation Branch，Jiangsu United Vocational and Technical College

School of Mechanical and Electrical Engineering，Heilongjiang Agricultural Engineering Vocational College

School of Mechanical Engineering，Harbin Institute of Technology

School of Mechanical Engineering,Qingdao University of Technological

School of Mechanical Engineering,Qingdao Technological University

⁰