Analysis of Inherent Characteristics of Robot Joint Transmission System

Mo Shuai; Hu Xiaosong; Yang Zhenning; Feng Zhiyou; Li Xu; Zhou Changpeng; Huang Yunsheng

doi:10.16578/j.issn.1004.2539.2022.10.012

您当前的位置：

首页 >

文章列表页 >

Analysis of Inherent Characteristics of Robot Joint Transmission System

Test·Analysis | 更新时间：2022-11-05

- Analysis of Inherent Characteristics of Robot Joint Transmission System
- Journal of Mechanical Transmission Vol. 46, Issue 10, Pages: 77-85(2022)
- 作者机构：
  
  1.天津工业大学机械工程学院，天津 300387
  2.江苏万基传动科技有限公司，江苏泰州 225400
  3.深圳市合发齿轮机械有限公司，广东深圳 518100
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2022.10.012
  CLC：
扫描看全文
莫帅,胡效松,杨振宁等.机器人关节传动系统固有特性分析[J].机械传动,2022,46(10):77-85.

Mo Shuai,Hu Xiaosong,Yang Zhenning,et al.Analysis of Inherent Characteristics of Robot Joint Transmission System[J].Journal of Mechanical Transmission,2022,46(10):77-85.
莫帅,胡效松,杨振宁等.机器人关节传动系统固有特性分析[J].机械传动,2022,46(10):77-85. DOI： 10.16578/j.issn.1004.2539.2022.10.012.

Mo Shuai,Hu Xiaosong,Yang Zhenning,et al.Analysis of Inherent Characteristics of Robot Joint Transmission System[J].Journal of Mechanical Transmission,2022,46(10):77-85. DOI： 10.16578/j.issn.1004.2539.2022.10.012.

摘要

机器人关节作为机器人的核心部件，主要由驱控系统和多级齿轮传动系统组成，在高转速、高负载下的齿轮传动系统动力学特性更加复杂。以机器人关节中齿轮传动系统为研究对象，采用集中参数法建立了其平移-扭转耦合动力学模型，根据牛顿第二定律建立了各构件动力学方程；分析了该系统的固有频率、模态应变能和模态动能，并研究了系统参数对固有频率的影响。结果表明，对于系统的模态能，在第15阶固有频率下的总应变能最大，此时系统整体变形最大；第24阶固有频率下的总动能最大，系统在该固有频率下的振动最为剧烈；系统参数对固有频率的影响主要体现为：高阶固有频率受影响较为明显；受系统刚度变化的影响，部分固有频率轨迹曲线逐渐接近后在某点附近会以较大的曲率快速分离，出现模态跃迁现象，在遇到频率相近时，会再次跃迁。

Abstract

As the core component of robots, the robot joint is mainly composed of drive control system and multi-stage gear transmission system. Under high speed and high load, the dynamic characteristics of gear transmission system are more complex. Taking the gear transmission system in the robot joint as the research object, the translation torsion coupling dynamic model is established by using the lumped parameter method, and the dynamic equations of each component are established according to Newton's second law. Therefore, the natural frequency, modal strain energy and modal kinetic energy of the system are analyzed, and the influence of system parameters on natural frequency is studied. The results show that for the modal energy of the system, the total strain energy is the largest at the 15th natural frequency, the overall deformation of the system is the largest, the total kinetic energy is the largest at the 24th natural frequency, and the vibration of the system is the most intense at this natural frequency; the influence of system parameters on natural frequency is mainly reflected in that higher-order natural frequency is obviously affected; affected by the change of system stiffness, some natural frequency trajectory curves gradually approach, and will quickly separate with large curvature near a certain point, resulting in modal transition. When the frequencies are similar, they will transition again.

关键词

机器人关节固有特性模态能固有频率模态跃迁

Keywords

Robot jointInherent characteristicsModal energyNatural frequencyModal transition

references

张铁，覃彬彬，刘晓刚.柔体动力学模型的机器人关节振动分析与抑制［J］.振动、测试与诊断，2019，39（2）：242-248.

ZHENG Tie，QIN Binbin，LIU Xiaogang.Vibration analysis and suppression of robot joints based on flexible dynamics model［J］.Journal of Vibration，Measurement & Diagnosis，2019，39（2）：242-248.

王均刚，王勇，霍志璞.风电齿轮箱多级行星齿轮耦合传动系统数学建模及振型［J］.四川大学学报（工程科学版），2013，45（3）：189-196.

WANG Jungang，WANG Yong，HUO Zhipu.Establishment of mathematic model and study of vibration modes for multi-stage planetary gear train of wind turbine gearboxes［J］.Journal of Sichuan University（Engineering Science Edition），2013，45（3）：189-196.

LIU Y Q，LONG Q，YANG Y P.Dynamic analysis of multistage gear driven system of wind turbine［J］.Applied Mechanics and Materials，2010，979（29-32）：1706-1710.

黄孝慈.基于目标参数优化的双模式多级齿轮传动机构受迫振动特性分析［J］.机械传动，2020，44（11）：145-151.

HUANG Xiaoci.Research on the forced vibration characteristic of the dual mode multistage gear transmission based on the objective parameter optimization［J］.Journal of Mechanical Transmission，2020，44（11）：145-151.

LI W，PANG D Q.Analytical investigation on geared rotor system with multi-body fault based on finite element method［J］.Journal of Vibration and Control，2019，25（2）：408-422.

张丽娟.基于混合离散方法的多级齿轮传动系统振动优化［J］.机械传动，2017，41（1）：155-159.

ZHANG Lijuan.Vibration optimization of multi-gear transmission system based on mixed-discrete method［J］.Journal of Mechanical Transmission，2017，41（1）：155-159.

李楠，王三民，杜佳佳.功率四分支齿轮传动系统的固有特性与动载系数［J］.航空动力学报，2013，28（2）：445-451.

LI Nan，WANG Sanmin，DU Jiajia.Natural characteristics and dynamic load coefficient of power four embranchments gear transmission［J］.Journal of Aerospace Power，2013，28（2）：445-451.

MO S，ZHANG T，JIN G G，et al.Analytical investigation on load sharing characteristics of herringbone planetary gear train with flexible support and floating sun gear［J］.Mechanism and Machine Theory，2020，144（2）：1-27.

MO S，ZHANG T，JIN G G，et al.Influence mechanism of multi-coupling error on the load sharing characteristics of herringbone gear planetary transmission system［J］.Proceedings of the Institution of Mechanical Engineers，2019，233（4）：792-816.

李国彦，李方义，刘浩华，等.含裂纹复合两级行星轮系振动特性研究［J］.振动工程学报，2018，31（3）：500-512.

LI Guoyan，LI Fangyi，LIU Haohua，et al.Vibration property analysis of compound two-stage planetary gear set with crack defect［J］.Journal of Vibration Engineering，2018，31（3）：500-512.

LU W J，ZHANG Y M，CHENG H C，et al.Research on vibration characteristics of multistage gears transmission system driven by internal and external excitation［J］.Journal of the Brazilian Society of Mechanical Sciences and Engineering，2018，40（11）：1-20.

SHAO R P，JIA P R，QI X K.3-D elastic coupling vibration and acoustical radiation characteristics of cracked gear under elastic support condition［J］.Journal of Vibration and Control，2017，23（9）：1548-1568.

鲍和云，李丰波，陆凤霞，等.某型变转速直升机传动系统动力学特性分析［J］.中南大学学报（自然科学版），2019，50（10）：2403-2416.

BAO Heyun，LI Fengbo，LU Fengxia，et al.Analysis of dynamic characteristics of a variable speed helicopter transmission system［J］.Journal of Central South University（Science and Technology），2019，50（10）：2403-2416.

黄晓冬，袁银男，欧阳天成，等.多级平行轴滚筒齿轮数学建模及动力学分析［J］.东南大学学报（自然科学版），2018，48（4）：605-612.

HUANG Xiaodong，YUAN Yinnan，OUYANG Tiancheng，et al.Mathematical modeling and dynamic analysis of multi-shaft cylinder gears［J］.Journal of Southeast University（Natural Science Edition），2018，48（4）：605-612.

王海霞，朱才朝，张磊，等.大型船用齿轮箱传动系统的动态耦合特性［J］.重庆大学学报，2010，33（1）：12-18.

WNAG Haixia，ZHU Caichao，ZHANG Lei，et al.Dynamical coupling characteristics of large marine gearbox transmission system［J］.Journal of Chongqing University，2010，33（1）：12-18.

朱才朝，王海霞，张磊，等.小倾角船用齿轮箱系统固有特性研究［J］.振动与冲击，2010，29（5）：123-127.

ZHU Caichao，WANG Haixia，ZHNAG Lei，et al.Natural dynamic characteristics of a gearbox system with a small inclination angle［J］.Journal of Vibration and Shock，2010，29（5）：123-127.

胡鹏，王奇斌，张义民.多级齿轮传动系统关键参数对响应的影响分析［J］.振动、测试与诊断，2015，35（3）：469-475.

HU Peng，WANG Qibin，ZHANG Yimin.Effect of key parameters on the dynamic performance of the multi-mesh gear system［J］.Journal of Vibration，Measurement & Diagnosis，2015，35（3）：469-475.

张栋林，朱如鹏，李苗苗，等.共轴对转封闭差动轮系固有特性及灵敏度分析［J］.航空动力学报，2021，36（4）：767-775.

ZHANG Donglin，ZHU Rupeng，LI Miaomiao，et al.Natural characteristics and sensitivity analysis of a coaxial contra-rotating encased differential gear train［J］.Journal of Aerospace Power，2021，36（4）：767-775.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Parameter Sensitivity Analysis of Natural Frequency of a Two Branch Herringbone Gear Transmission System

Research on the Influence of the RV-40E Reducer Modal on Its Transmission Error

Influence Analysis of Sprocket Tooth Thickness Effect on Natural Frequency of Mining Scraper Conveyor Chain Drive System

Study on Electromechanical Coupling Dynamic Characteristics of Robot Joint Servo Transmission System

Research on Dynamic Characteristics of Robot Joint System Under Impact Load

Related Author

No data

Related Institution

School of Mechanical Engineering, Northwestern Polytechnical University

Wuhan Jinghua Reducer Manufacturing Co., Ltd.

School of Mechanical Engineering, Hubei University of Technology

Shendong Coal Group Company, CHN Energy

Shenzhen Hefa Gear Machinery Co.， Ltd.

⁰