Research on Discontinuous Contact Intra-strand Steel Stress of Steel Rope Ring CVT

Wu Zhang; Weixiong Liu; Lü Changlei; Feiyan Han

doi:10.16578/j.issn.1004.2539.2022.08.016

您当前的位置：

首页 >

文章列表页 >

Research on Discontinuous Contact Intra-strand Steel Stress of Steel Rope Ring CVT

Test·Analysis | 更新时间：2022-09-23

- Research on Discontinuous Contact Intra-strand Steel Stress of Steel Rope Ring CVT
- Journal of Mechanical Transmission Vol. 46, Issue 8, Pages: 100-104(2022)
- 作者机构：
  
  1.西安科技大学机械工程学院，陕西西安 710054
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2022.08.016
  CLC：
扫描看全文
张武,刘卫雄,吕常磊等.钢绳环式CVT非连续接触股内钢丝应力研究[J].机械传动,2022,46(08):100-104.

Zhang Wu,Liu Weixiong,Changlei Lü,et al.Research on Discontinuous Contact Intra-strand Steel Stress of Steel Rope Ring CVT[J].Journal of Mechanical Transmission,2022,46(08):100-104.
张武,刘卫雄,吕常磊等.钢绳环式CVT非连续接触股内钢丝应力研究[J].机械传动,2022,46(08):100-104. DOI： 10.16578/j.issn.1004.2539.2022.08.016.

Zhang Wu,Liu Weixiong,Changlei Lü,et al.Research on Discontinuous Contact Intra-strand Steel Stress of Steel Rope Ring CVT[J].Journal of Mechanical Transmission,2022,46(08):100-104. DOI： 10.16578/j.issn.1004.2539.2022.08.016.

摘要

为探究弯曲钢丝绳与连续、非连续绳槽接触时股内钢丝应力分布规律，以6×19+IWS右交互捻钢丝绳为研究对象，分别建立钢丝绳与连续、非连续绳槽接触的有限元模型，分析了连续和非连续接触时股内钢丝应力分布。结果表明，在连续、非连续接触下，与绳槽接触的侧股外层钢丝等效应力值最大，股与股接触处钢丝次之，其他位置钢丝等效应力值最小；在相同轴向载荷下，非连续接触时钢丝绳产生的等效应力变化幅度高于连续接触时钢丝绳等效应力；非连续绳槽表面接触应力值比连续绳槽大39.5%，非连续接触时表面钢丝绳最大接触应力比连续接触时大5.08%；进行连续和非连续接触下钢丝绳的磨损试验发现，非连续接触时侧股外层钢丝磨痕长度、宽度均值比连续接触时分别高25.5%和13.5%，与仿真结果一致。

Abstract

In order to explore the stress distribution of steel wire in the strand when the curved steel rope is in contact with continuous and discontinuous grooves， taking the 6×19+IWS right cross-twisted steel rope as the research object， the finite element models of contact between steel ropes and continuous and discontinuous grooves are established respectively， and the stress distribution of the steel wire in continuous and discontinuous contact is analyzed. The results show that under the condition of continuous and discontinuous contact， the equivalent stress value of the outer steel rope in contact with the rope groove is the largest， followed by the steel rope at the contact between the strand and the strand， and the equivalent force value of the steel rope at other positions is the smallest under the same axial load. The change range of equivalent stress produced by steel rope in discontinuous contact is higher than that in continuous contact. The surface contact stress of discontinuous rope grooves is 39.5% larger than that of continuous rope grooves， and the maximum contact stress of surface steel rope in discontinuous contact is 5.08% higher than that in continuous contact. The wear test of steel rope under continuous and discontinuous contact shows that the average length and width of steel rope wear scar in discontinuous contact are 25.5% and 13.5% higher than those in continuous contact， respectively， which are consistent with the simulation results.

关键词

钢绳环式CVT非连续接触应力与变形磨痕

Keywords

Steel rope ring CVTDiscontinuous contactStress and deformationWear scar

references

CRUZADO A，URCHEGUI M A，GOMEZ X.Finite element modeling of fretting wear scars in the thin steel wires：application in crossed cylinder arrangements［J］.Wear，2014，318（S1/S2）：98-105.

ZHANG W，ZHANG X Q，ZHANG C W，et al.Theory and implementation of no-joint wire rope spatial geometry modeling［J］.Mathematical Problems in Engineering，2019，644：1-11.

张武，郭卫，路正雄，等.一种新型金属带式无级变速器设计与分析［J］.机械传动，2015，39（9）：59-61.

ZHANG Wu，GUO Wei，LU Zhengxiong，et al.Design and analysis of a new metal belt CVT［J］.Journal of Mechanical Transmission，2015，39（9）：59-61.

ERDONMEZ C，IMRAK C E.A finite element model for independent wire rope core with double helical geometry subjected to axial loads［J］.Sadhana，2011，36（6）：995-1008.

STANOVA E，FEDORKO G，FABIAN M，et al.Computer modelling of wire strands and ropes part I：theory and computer implementation［J］.Advances in Engineering Software，2011，42（6）：305-315.

马军，葛世荣，张德坤.钢丝绳股内钢丝应力—应变分布的计算模型及数值模拟［J］.机械工程学报，2009，45（11）：277-282.

MA Jun，GE Shirong，ZHANG Dekun.Calculating model and numerical simulation of stress-strain distribution of wires within strands［J］.Journal of Mechanical Engineering，2009，45（11）：277-282.

吴娟，寇子明，刘玉辉，等.弯曲钢丝绳股内钢丝应力应变数值模拟［J］.煤炭学报，2015，40（6）：1463-1468.

WU Juan，KOU Ziming，LIU Yuhui，et al.Numerical simulation of steel wire stress and strain in the strand of bending steel wire rope［J］.Journal of China Coal Society，2015，40 （6）：1463-1468.

吴娟，寇子明，刘玉辉，等.独立钢丝绳芯钢丝绳应力及变形分布［J］.煤炭学报，2014，39（11）：2340-2347.

WU Juan，KOU Ziming，LIU Yuhui，et al.Stress and deformation distribution of independent wire rope core wire rope［J］.Journal of China Coal Society，2014，39（11）：2340-2347.

WANG D G，ZHANG D K，WANG S Q，et al.Finite element analysis of hoisting rope and fretting wear evolution and fatigue life estimation of steel wires［J］.Engineering Failure Analysis，2013，27：173-193.

ZHANG J，WANG D G，ZHANG D K，et al.Dynamic contact and slip characteristics of bent hoisting rope in coal mine［J］.Journal of the Brazilian Society of Mechanical Sciences & Engineering，2018，40（3）：1-9.

郭卫，路正雄，张武.基于Pro/E的圆弧弯曲钢丝绳建模理论及几何实现［J］.中国机械工程，2015，26（17）：2363-2368.

GUO Wei，LU Zhengxiong，ZHANG Wu.Geometric modeling theory of bent wire rope basedon Pro/E［J］.China Mechanical Engineering，2015，26（17）：2363-2368.

ZHANG W，WU J L，LIU Y S，et al.Research on the elastic properties of discontinuous contact wire rope for WR-CVT［J］.Advances in Materials Science and Engineering，2021（6）：1-11.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

⁰