Effect of Main Bearing Surface Profile on Crankshaft Lubrication and Vibration Characteristic

Guixiang Zhu; Junsheng Zhao; Chunjian Li; Jialin Wang; Min Liu; Zhihao Yang

doi:10.16578/j.issn.1004.2539.2022.03.017

您当前的位置：

首页 >

文章列表页 >

Effect of Main Bearing Surface Profile on Crankshaft Lubrication and Vibration Characteristic

Test·Analysis | 更新时间：2022-09-24

- Effect of Main Bearing Surface Profile on Crankshaft Lubrication and Vibration Characteristic
- Journal of Mechanical Transmission Vol. 46, Issue 3, Pages: 108-115(2022)
- 作者机构：
  
  1.潍柴动力股份有限公司内燃机可靠性国家重点实验室，山东潍坊 261061
  2.中北大学机械工程学院，山西太原 030051
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2022.03.017
  CLC：
扫描看全文
朱桂香,赵俊生,李春建等.主轴承表面型线对曲轴润滑与振动特性的影响[J].机械传动,2022,46(03):108-115.

Zhu Guixiang,Zhao Junsheng,Li Chunjian,et al.Effect of Main Bearing Surface Profile on Crankshaft Lubrication and Vibration Characteristic[J].Journal of Mechanical Transmission,2022,46(03):108-115.
朱桂香,赵俊生,李春建等.主轴承表面型线对曲轴润滑与振动特性的影响[J].机械传动,2022,46(03):108-115. DOI： 10.16578/j.issn.1004.2539.2022.03.017.

Zhu Guixiang,Zhao Junsheng,Li Chunjian,et al.Effect of Main Bearing Surface Profile on Crankshaft Lubrication and Vibration Characteristic[J].Journal of Mechanical Transmission,2022,46(03):108-115. DOI： 10.16578/j.issn.1004.2539.2022.03.017.

摘要

以某六缸柴油机主轴承-主轴颈为研究对象，基于弹性流体润滑理论和微凸峰接触理论，考虑轴颈倾斜和主轴承表面粗糙度等因素，建立柔性整机体下的主轴承润滑特性模型，分析了主轴承表面型线对主轴承润滑特性与主轴颈振动特性的影响。结果表明，相比于不计入主轴承表面型线的结果，计入主轴承表面型线时，主轴承的最小油膜厚度增加了75.53%，最大油膜压力减小了6.15%，平均摩擦损失降低了2%，主轴颈的水平弯曲振动幅值减小了6%，竖直弯曲振动幅值减小了5%，轴向振动和扭转振动幅值均减小了2%。随着主轴承表面型线高度的增加，主轴承的最小油膜厚度增加，最大油膜压力减小，平均摩擦损失降低，最大粗糙接触压力的幅值和出现次数均降低；主轴颈的弯曲振动、轴向振动和扭转振动幅值均减小。

Abstract

Taking the main bearing-main journal of a six-cylinder diesel engine as the research object，based on the elastic- -fluid lubrication theory and the micro-bump contact theory and considering factors such as journal misalignment and main bearing surface roughness，the main bearing lubrication characteristics model under the flexible whole body is established，and the influence of the main bearing surface profile on the main bearing lubrication characteristics and main journal vibration characteristics is analyzed. The results show that，compared with the result that does not take into account the main bearing surface profile，when the main bearing surface profile is included，the minimum oil film thickness of the main bearing is increased by 75.53%，the maximum oil film pressure is reduced by 6.15%，the average friction loss is reduced by 2%，the horizontal flexural vibration amplitudes of the main journal is reduced by 6%，the vertical flexural vibration amplitudes is reduced by 5%，and both the axial vibration and torsional vibration amplitudes are reduced by 2%. With the increase of the main bearing surface profile height，the minimum oil film thickness of the main bearing increases，the maximum oil film pressure decreases，the average friction loss decreases，and both the maximum roughness contact force amplitude and the number of occurrences are reduced; the amplitudes of flexural vibration，axial vibration and torsional vibration of the main journal are all reduced.

关键词

主轴承表面型线曲轴润滑特性振动特性

Keywords

Main bearingSurface profileCrankshaftLubrication characteristicVibration characteristic

references

宋新涛，孙士青，吴维.考虑局部磨损和空化效应的径向滑动轴承混合润滑分析［J］.华南理工大学学报（自然科学版），2020，48（8）：102-107.

SONG Xintao，SUN Shiqing，WU Wei.Hybrid lubrication analysis of radial journal bearing considering local wear and cavitation effect［J］.Journal of South China University of Technology （Natural Science Edition），2020，48（8）：102-107.

SHARMA S，AWASTHI R K. Performance of hydrodynamic journal bearing operating under transient wear［J］.Mechanics and Mechanical Engineering，2020，22（1）：153-170.

李涵，赵俊生，崔随现，等.形状误差对内燃机主轴承润滑性能的影响［J］.润滑与密封，2018，43（3）：81-87.

LI Han，ZHAO Junsheng，CUI Suixian，et al.Influence of shape error on lubrication performance of internal combustion engine main bearing［J］.Lubrication Engineering，2018，43（3）：81-87.

林建辉，王炳轩，魏立队.整机体下船舶柴油机主轴承热弹流体动力混合润滑研究［J］.大连海事大学学报，2020，46（4）：102-111.

LIN Jianhui，WANG Bingxuan，WEI Lidui.Study on thermoelastic hydrodynamic mixed lubrication of main bearing of marine diesel engine under whole body［J］.Journal of Dalian Maritime University，2020，46（4）：102-111.

章朝栋，赵俊生，朱桂香，等.曲轴平衡率对主轴承润滑特性的影响［J］.内燃机学报，2020，38（2）：178-184.

ZHANG Chaodong，ZHAO Junsheng，ZHU Guixiang，et al.Influence of crankshaft balance rate on lubrication characteristics of main bearing［J］.Journal of Internal Combustion Engines，2020，38（2）：178-184.

WEI L D，DUAN H J，ZHANG S L，et al.An EHD-mixed lubrication analysis of main bearings for diesel engine based on coupling between flexible whole engine block and crankshaft［J］.Industrial Lubrication and Tribology，2015，67（2）：150-158.

尹明虎，陈国定，高当成，等.3种微织构对径向滑动轴承性能的影响［J］.哈尔滨工业大学学报，2016，48（1）：159-164.

YIN Minghu，CHEN Guoding，GAO Dangcheng，et al.Influence of three kinds of micro-textures on the performance of radial plain bearing［J］.Journal of Harbin Institute of Technology，2016，48（1）：159-164.

BI F R I，SHAO K，LIU C，et al.Analysis of thermoelastohydr-odynamic performance of journal misaligned engine main bearings［J］.Chinese Journal of Mechanical Engineering，2015，28（3）：511-520.

MATTHIEU D，CEZAR T，VINCENT C.Optimization of contact profiles using super-ellipse［J］.SAE International Journal of Materials and Manufacturing，2017，10（2）：234-244．

蔡晓霞，孙军，刘利平，等.计及机体变形的内燃机主轴承弹性流体动力润滑分析［J］.摩擦学学报，2010，30（2）：118-122.

CAI Xiaoxia，SUN Jun，LIU Liping，et al.Analysis of elastohydro dynamic lubrication of internal combustion engine main bearingconsidering body deformation［J］.Tribology，2010，30（2）：118-122.

阮登芳，陈黎，高真超.轴瓦轮廓修形对发动机连杆轴承磨损性能的影响［J］.中国机械工程，2019，30（10）：1207-1211.

RUAN Dengfang，CHEN Li，GAO Zhenchao.Influence of shaft profile modification on wear performance of engine connecting rod bearing［J］.China Mechanical Engineering，2019，30（10）：1207-1211.

李正文，赵俊生，李涵，等.柴油机曲轴润滑与弯曲振动耦合影响研究［J］.润滑与密封，2020，45（1）：129-134.

LI Zhengwen，ZHAO Junsheng，LI Han，et al.Study on coupling effect of crankshaft lubrication and bending vibration of diesel engine［J］.Lubrication Engineering，2020，45（1）：129-134.

申传鹏.齿面微观几何轮廓对啮合振动及润滑特性影响的研究［D］，乌鲁木齐：新疆大学，2018：35-41．

SHEN Chuanpeng.Study on influence of micro-geometry profile of tooth surface on meshing vibration and lubrication characteristi-cs［D］.Urumqi：Xinjiang University，2018：35-41.

杜媛英，李明.考虑轴颈倾斜和表面粗糙度的水润滑橡胶轴承弹流润滑分析［J］.船舶力学，2020，24（4）：465-473.

DU Yuanying，LI Ming.Elastohydrodynamic lubrication analysis of water lubricated rubber bearing considering journal inclination and surface roughness［J］.Journal of Ship Mechanics，2020，24（4）：465-473.

何芝仙，桂长林，李震，等.计入曲轴倾斜时曲轴-轴承系统动力学摩擦学和弹性力学耦合分析［J］.内燃机工程，2009，30（3）：86-92.

HE Zhixian，GUI Changlin，LI Zhen，et al.Coupling analysis of dynamic tribology and elastic mechanics of crankshaft-bearing system considering crankshaft inclination［J］.Internal Combustion Engine Engineering，2009，30（3）：86-92.

孙军，桂长林，李志远.轴变形产生的轴颈倾斜对滑动轴承润滑影响的试验研究［J］.机械工程学报，2006（7）：159-163.

SUN Jun，GUI Changlin，LI Zhiyuan.Experimental study on influence of journal inclination caused by shaft deformation on lubrication of sliding bearing［J］.Journal of Mechanical Engineering，2006（7）：159-163.

GU T，WANG Q，XIONG S，et al.Profile design for misaligned journal bearings subjected to transient mixed-lubrication［J］.Journal of Tribology，2019，141（7）：1-32.

温诗铸，田煜，黄平.摩擦学原理［M］.北京：清华大学出版社，2018：19-20.

WEN Shizhu，TIAN Yu，HUANG Ping.Principles of tribology［M］.Beijing：Tsinghua University Press，2018：19-20.

MENG X H，GU C X，XIE Y B，et al.Elasto-plastic contact of rough surfaces：a mixed-lubrication model for the textured surface analysis［J］.Meccanica，2017，52（7）：1541-1559.

CAGLAR H，CAGLAR N，ELFAITURI K.B-spline interpolation compared with finite difference，finite element and finite volume methods which applied to two-point boundary value problems［J］.Applied Mathematics & Computation，2006，175（1）：72-79.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on the Effect of Water Pollution in Lubricant on Gear Thermal Elastohydrodynamic Lubrication Characteristic

Influence of Radial Journal Profile of Main Bearing on Lubrication State

Vibration Characteristic Analysis of High-speed Train Gear Transmission System Under Track Irregularity

Research on Low Noise Method of Passenger Car Gearbox

Study on the Nonlinear Vibration Characteristic of Bending-torsional Coupled Single-stage Gear

Related Author

No data

Related Institution

Wuxi Transportation Branch，Jiangsu United Vocational and Technical College

School of Mechanical and Electrical Engineering，Heilongjiang Agricultural Engineering Vocational College

School of Mechanical Engineering，Harbin Institute of Technology

CRRC Nanjing Puzhen Vehicle Co.，Ltd.

Key Laboratory of Transportation Tools and Equipment of Ministry of Education，School of Mechatronics and Vehicle Engineering，East China Jiaotong University

⁰