Optimization Algorithm of Dynamic Control Strategy based on CVT Efficiency

Wang Zhihong; Wang Jianyun; Liu Shichao; Yan Hao; Du Changqing

doi:10.16578/j.issn.1004.2539.2020.06.010

您当前的位置：

首页 >

文章列表页 >

Optimization Algorithm of Dynamic Control Strategy based on CVT Efficiency

Design· Calculation | 更新时间：2022-10-20

- Optimization Algorithm of Dynamic Control Strategy based on CVT Efficiency
- Journal of Mechanical Transmission Vol. 44, Issue 6, Pages: 54-60(2020)
- 作者机构：
  
  1.武汉理工大学现代汽车零部件技术湖北省重点实验室，湖北武汉 430070
  2.武汉理工大学汽车零部件技术湖北省协同创新中心，湖北武汉 430070
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2020.06.010
  CLC：
扫描看全文
王志红,王剑云,刘士超等.基于CVT效率的动力性控制策略优化算法[J].机械传动,2020,44(06):54-60.

Wang Zhihong,Wang Jianyun,Liu Shichao,et al.Optimization Algorithm of Dynamic Control Strategy based on CVT Efficiency[J].Journal of Mechanical Transmission,2020,44(06):54-60.
王志红,王剑云,刘士超等.基于CVT效率的动力性控制策略优化算法[J].机械传动,2020,44(06):54-60. DOI： 10.16578/j.issn.1004.2539.2020.06.010.

Wang Zhihong,Wang Jianyun,Liu Shichao,et al.Optimization Algorithm of Dynamic Control Strategy based on CVT Efficiency[J].Journal of Mechanical Transmission,2020,44(06):54-60. DOI： 10.16578/j.issn.1004.2539.2020.06.010.

摘要

传统的无级变速器（Continuously Variable Transmission，CVT）动力性控制策略以最大发动机功率为控制目标。由于CVT效率在不同负载下变化较大，故控制发动机功率最大并不能保证此时的整车驱动功率也达到最大。为此，设计了矩阵优化算法，以最大整车驱动功率为目标，计算得到各踏板开度及车速下的CVT动力性速比。利用GT-drive软件建立整车模型，对优化前后的控制策略进行仿真对比分析。结果表明，优化后的控制策略使汽车在各个踏板开度下，整车驱动功率和最高车速都有不同程度的提升。

Abstract

The traditional Continuously Variable Transmission （CVT） dynamic control strategy takes the maximum engine power as the control target. As CVT efficiency varies greatly under different loads， the maximum engine power cannot guarantee the maximum driving power at the same time. For this， the matrix optimization algorithm is designed to calculate the CVT dynamic speed ratio under different pedal opening and vehicle speed with the maximum driving power as the target. A whole vehicle model is established by using GT-drive software， and the control strategies before and after optimization are simulated and compared. The result indicates that the optimized control strategy can improve the driving power and the maximum vehicle speed to different degrees under each pedal opening.

关键词

CVT效率控制策略优化算法 GT-drive 整车模型

Keywords

CVT efficiencyControl strategyOptimization algorithmGT-driveWhole vehicle model

references

CARBONE G，MANGIALARDI L，MANTRIOTA G.Fuel consumption of a midclass vehicle with infinitely variable transmission[J].SAE International Journal of Engines，2001，110（3）：2474-2484.

SLUIS V D，DONGEN F V，SPIJK T V，et al.Fuel consumption potential of the push belt CVT[J].Proceedings of FISITA 2006 World Automobile Congress，2006：1-12.

王成.金属带式无级变速器速比控制策略研究[D].长春：吉林大学，2007：4-9.

WANG Cheng.Study on speed ratio control strategy of metal belt CVT[D].Changchun：Jilin University，2007：4-9.

林治楠.金属带式无级变速轿车的动态建模与性能仿真[D].哈尔滨：哈尔滨理工大学，2007：5-6.

LIN Zhinan.Dynamic modeling and performance simulation of metal belt type continuously variable transmission cars[D].Harbin：Harbin University of Science and Technology，2007：5-6.

TAKAHARA H，YASUE H，HABUCHI R，et al.Continuously variable transmission control system for toyota intelligent idling stop system[J].SAE Technical Paper Series，2004:2004-01-1635.

OHASHI A，SATO Y，KAJIKAWA K，et al.Development of high-efficiency CVT for luxury compact vehicle[J].SAE Technical Paper Series，2005：2005-01-1019.

MASHADI B，EMADI S.Dual-mode power-split transmission for hybrid electric vehicle[J].IEEE Transactions Vehicular Technology,2010，59（7）：3223-3232.

LIU J，PENG H.A systematic design approach for two planetary gear split hybrid vehicles[J].Vehicle System Dynamics,2010，48（11）：1395-1412.

ZAREMBA A T，SATO C，JENNIGS M.Methodology for assessment of alternative hybrid electric vehicle powertrain system architectures[J].SAE International Journal of Alternative Powertrains，2012，1（1）：240-248.

罗勇，孙东野，胡丰宾，等.无级变速汽车最佳动力性优化控制策略[J].重庆大学学报，2010，33（3）：1-6.

LUO Yong，SUN Dongye，HU Fengbin，et al.Optimal dynamic performance Ccntrol strategy for continuously variable transmission vehicles [J].Journal of Chongqing University，2010，33（3）：1-6.

罗勇.金属带式无级变速传动系统匹配控制研究[D].重庆：重庆大学，2010：16-18，20-21.

LUO Yong.Research on matching control of metal belt type continuously variable transmission system[D].Chongqing：Chongqing University，2010：16-18，20-21.

秦大同，邢子坤，王建宏.基于动力学和可靠性的风力发电齿轮传动系统参数优化设计[J].机械工程学报，2008，44（7）：24-31.

QIN Datong，XING Zikun，WANG Jianhong.Optimal design of parameters of wind power gear transmission system based on dynamics and reliability[J].Journal of Mechanical Engineering，2008，44（7）：24-31.

王歆誉.金属带式无级变速器传动特性仿真研究[D].长沙：湖南大学，2015：39-41.

WANG Yuyu.Simulation study on transmission characteristics of metal belt type continuously variable transmission[D].Hunan：Hunan University，2015：39-41.

SONG J C，WANG C Z.Modeling and simulation of hydraulic control system for vehicle continuously variable transmission[J].IEEE Conference on Industrial Electronics and Applications，2008，7（12）：799-803.

AKEHURST，VAUGHANND，PARKERDA，et al.Modelling of loss mechanisms in a pushing metal V-belt continuously variable transmission，part 1：torque losses due to band friction[J].Proceedings of the Institution of Mechanical Engineers，Part D：Journal of Automobile Engineering，2004，218（11）：1269-1281.

PATEL D，ELY J，OVERSON M.CVT drive research study[J].SAE International Special Pubications，2005，1979：131-138.

LI Q T，ZHOU X，WANG S，et al.Power split transmission with continuously variable planetary ratio[J].Mechanism and Machine Theory，2019，140：765-780.

NILABH S，IMTIAZ H.Transient dynamics of metal V-belt CVT：Effects of pulley flexibility and friction characteristic[J].Journal of Computational and Nonlinear Dynamics，2007，2（1）：86.

SRIVASTAVA N，HAQUE I.Transient dynamics of metal V-belt CVT：effects of band pack slip and friction characteristic[J].Mechanism and Machine Theory，2008，43（4）：459-479.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

⁰