2-（CRR）<sub>2</sub>R Parallel Mechanism with Decoupling-reducing Structure and Its Kinematics Analysis

Junkun Hong; Linxian Che; Li Du; Shikun Wen; Guowang Chen

doi:10.16578/j.issn.1004.2539.2019.04.010

您当前的位置：

首页 >

文章列表页 >

2-（CRR）₂R Parallel Mechanism with Decoupling-reducing Structure and Its Kinematics Analysis

Design· Calculation | 更新时间：2022-10-03

- 2-（CRR）₂R Parallel Mechanism with Decoupling-reducing Structure and Its Kinematics Analysis
- Journal of Mechanical Transmission Vol. 43, Issue 4, Pages: 51-60(2019)
- 作者机构：
  
  1.重庆理工大学机械工程学院，重庆 400054
  2.重庆工程职业技术学院机械工程学院，重庆 402260
  3.重庆工商大学制造装备机构设计与控制重庆市重点实验室，重庆 400067
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2019.04.010
  CLC：
扫描看全文
洪俊坤,车林仙,杜力等.2-（CRR）₂R结构降耦并联机构及其运动学分析[J].机械传动,2019,43(04):51-60.

Hong Junkun,Che Linxian,Du Li,et al.2-（CRR）₂R Parallel Mechanism with Decoupling-reducing Structure and Its Kinematics Analysis[J].Journal of Mechanical Transmission,2019,43(04):51-60.
洪俊坤,车林仙,杜力等.2-（CRR）₂R结构降耦并联机构及其运动学分析[J].机械传动,2019,43(04):51-60. DOI： 10.16578/j.issn.1004.2539.2019.04.010.

Hong Junkun,Che Linxian,Du Li,et al.2-（CRR）₂R Parallel Mechanism with Decoupling-reducing Structure and Its Kinematics Analysis[J].Journal of Mechanical Transmission,2019,43(04):51-60. DOI： 10.16578/j.issn.1004.2539.2019.04.010.

摘要

提出一种能实现三移动一转动（3T1R）的新型完全对称4-CRU并联机构，其4条支链结构完全相同。基于单开链理论及结构降耦原理，对4-CRU并联机构进行结构降耦设计，得到耦合度,κ,=1的低耦合度2-（CRR）,2,R并联机构。其优点在于动平台由两条混合支链并联构成，且支链完全对称，机构姿态转角相对较大。2-（CRR）,2,R并联机构耦合度降为1，极大地降低了机构位置正解的难度，有利于机构运动学分析。根据该机构的几何关系与运动约束，建立位置正解的一维搜索模型，再应用黄金分割法求出全部高精度位置正解。推导出机构位置逆解方程，应用数值实例验证了位置正、逆解的正确性。采用矢量法对机构动平台速度及加速度进行分析，得出速度及加速度正、逆解，并利用MATLAB软件编程进行数值计算。同时，应用Adams进行运动学仿真分析，验证了自由度分析的正确性；其运动学分析曲线与MATLAB计算结果一致，表明文中建立的解析模型和分析方法是正确、可行的。

Abstract

A new kind of parallel mechanism is proposed， which can realize three mobile one rotation （3T1R）， and it’s a perfectly symmetrical parallel mechanism of the 4-CRU branch， and then its four branched chains are identical in structure. Based on the theory of SOC and the principle for the structure coupling-reducing， structural decoupling design of 4-CRU parallel mechanism is carried out， and a new 2-（CRR）,2,R type parallel mechanism with lower coupling degree of ,κ,=1 is proposed. And the advantage of it is that the dynamic platform is composed of two chains in parallel， the angle of the mechanism is relatively large. The coupling degree of 2-（CRR）,2,R parallel mechanism is reduced to 1， which greatly reduced the difficulty of the positive solution of mechanism position and is conducive to the kinematics analysis. Based on the geometry and motion constraints， the one-dimensional search model of the position positive solution is established， then all the high precision position positive solutions are obtained by the golden section method. The inverse solution equation of the mechanism position is derived， and the correctness of the positive and negative solutions is verified by numerical examples. The velocity and acceleration of the moving platform are analyzed by vector method， the velocity and acceleration of the mechanism are obtained， and the numerical calculation is carried out by MATLAB. At the same time， simulation verification is carried out in Adams， the correctness of the degree of freedom analysis is verified. The kinematics analysis curve is consistent with the MATLAB calculation results， indicating that the analytical model and analysis method established in this paper is correct and feasible.

关键词

并联机构结构降耦结构分析运动学分析Adams仿真

Keywords

Parallel mechanismStructure coupling-reducingStructure analysisKinematics analysisAdams simulation

references

赵铁石，陈江，王家春，等. 4-UPU并联机器人机构及其运动学［J］. 中国机械工程， 2005， 16（22）： 2034- 2038.

SALGADO O， ALTUZARRA O， PETUYA V， et al. Synthesis and design of a novel 3T1R fully-parallel manipulator［J］. Journal of Mechanical Design， 2008， 130（4）： 137-139.

BRIOT S， BONEV I A. Pantopteron-4： a new 3T1R decoupled parallel manipulator for pick-and-place applications［J］. Mechanism and Machine Theory， 2010， 45（5）： 707-721.

刘辛军，谢福贵，王立平，等. 一种可实现SCARA运动的四自由度单动平台并联机构： 201210435375.1［P］. 2013-02-13.

沈惠平，尹洪贺，邵国为，等. 低耦合度3T1R并联操作手设计与运动学分析［J］. 农业机械学报， 2017， 48（5）： 405-412.

杨桂林，吴存存，陈庆盈，等. 3T1R并联机构运动学分析与优化设计［J］. 农业机械学报， 2017， 48（12）： 386-394.

贺磊盈，涂叶凯，叶伟，等. 一种可整周回转的新型3T1R并联机构运动学分析［J］. 机械工程学报， 2018， 54（11）：151-160.

尹洪波，沈惠平，邓嘉鸣，等. 球面并联机构的结构降耦及其位置正解求解［J］. 机械科学与技术， 2015， 34（1）： 51-55.

沈惠平，朱小蓉，尹洪波，等. 并联机构的结构降耦原理及其设计方法［J］. 机械工程学报， 2016， 52（23）：102-113.

李菊，曾氢菲，沈惠平，等. SCARA并联机构拓扑分析与其低耦合度机型设计［J］. 农业机械学报， 2017， 48（11）：405-416.

许可，沈惠平，邓嘉鸣，等. 3-RRR平面并联机构的拓扑结构优化及其运动学性能改善［J］. 机械科学与技术， 2017， 36（12）： 1866-1872.

杨廷力，刘安心，罗玉峰，等. 机器人机构拓扑结构设计构设计［M］. 北京：科学出版社， 2012：6-17.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Kinematics Analysis of a Planar Symmetric (CRR)₂S-(3R)₂R Parallel Mechanism

Kinematics Analysis of 3T1R 4-PRP_aU Parallel Mechanism

Configuration Design and Kinematics Analysis of a New Type of a Quadruped Robot Leg Mechanism

Comparative Analysis of the Workspace of 3-RSS and 3-RUU Coaxial Drive Layout Parallel Robots

Kinematics Analysis of a 2PRP_aU-2PSS Parallel Mechanism

Related Author

No data

Related Institution

School of Intelligent Manufacturing and Traffic， Chongqing Vocational Institute of Engineering

College of Mechanical Engineering and Automation, Liaoning University of Technology

School of Mechanical Engineering, North University of China

School of Mechanical Engineering, Chongqing Technology and Business University

Chongqing Municipal Key Laboratory of Mechanism Design and Control for Manufacturing Equipment,Chongqing Technology and Business University

⁰

2-（CRR）2R Parallel Mechanism with Decoupling-reducing Structure and Its Kinematics Analysis

DOI：10.16578/j.issn.1004.2539.2019.04.010

摘要

Abstract

关键词

Keywords

references

2-（CRR）₂R Parallel Mechanism with Decoupling-reducing Structure and Its Kinematics Analysis