Dynamic Simulation Analysis of Engine Timing Belt System based on AVL

Guo Jianhua; Li Wenhua; Shao Yue; Wu Yizhen; Jiang Hongyuan

doi:10.16578/j.issn.1004.2539.2017.11.022

您当前的位置：

首页 >

文章列表页 >

Dynamic Simulation Analysis of Engine Timing Belt System based on AVL

更新时间：2022-10-20

- Dynamic Simulation Analysis of Engine Timing Belt System based on AVL
- Vol. 41, Issue 11, Pages: 111-114(2017)
- 作者机构：
  
  1. 齐齐哈尔大学机电工程学院
  2. 无锡市贝尔特胶带有限公司
  3. 哈尔滨工业大学机械工程学院
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2017.11.022
  CLC：
扫描看全文
[1]郭建华,李文华,邵悦,吴贻珍,姜洪源.基于AVL发动机同步带正时系统动态仿真分析[J].机械传动,2017,41(11):111-114.

Guo Jianhua, Li Wenhua, Shao Yue, et al. Dynamic Simulation Analysis of Engine Timing Belt System based on AVL. [J]. 41(11):111-114(2017)
[1]郭建华,李文华,邵悦,吴贻珍,姜洪源.基于AVL发动机同步带正时系统动态仿真分析[J].机械传动,2017,41(11):111-114. DOI： 10.16578/j.issn.1004.2539.2017.11.022.

Guo Jianhua, Li Wenhua, Shao Yue, et al. Dynamic Simulation Analysis of Engine Timing Belt System based on AVL. [J]. 41(11):111-114(2017) DOI： 10.16578/j.issn.1004.2539.2017.11.022.

摘要

针对汽车发动机同步带正时系统,利用AVL-Excite Timing Drive进行正时系统运行一个周期时的动态仿真分析,研究带在松、紧边和各轮接触时载荷变化规律。结果表明,在惰轮和排气凸轮轴带轮跨距间带的动态张力和动态张力波动幅值最大;曲轴带轮上带齿受载最大,并对啮入端的带齿载荷的峰值机理进行了研究。在系统主要振源振动性能分析基础上,优化了系统参数,仿真表明主要振源振动得到减小,也减小了系统传动误差。

Abstract

For the automobile engine timing belt system,by using the AVL-Excite Timing Drive to carry out a periodic dynamic simulation analysis. The variation law of the load when the loose and tight of belt contact with pulley is studied. The results show that dynamic tension and its fluctuation of the belt between the idler and the exhaust camshaft pulley are the largest. And the peak mechanism of the belt toot load is studied. Based on the analysis of the vibration performance of the main vibration source,the system parameters are optimized. The results show that the vibration of the main vibration source is reduced and the transmission error of is reduced.

关键词

同步带正时系统动态张力啮合传动振动

Keywords

Synchronous beltTiming systemDynamic tensionMeshing driveVibration

references

Views

151

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Contact Simulation and Dynamic Performance Test of Ease-off Modified High Reduction Hypoid Gears

Discussion on Main Influencing Factor of Wear Resistance of Pre-lubricating Roller Chain

Mechanism Analysis and Experimental Study on Friction Noise of Vehicle V-ribbed Belt

Study on Vibration Suppression of Bevel Gear with Integral Squeeze Film Damper

Experimental Analysis of Vibration and Noise Characteristic of Helical Gear with Nano-lubricant Additive

Related Author

No data

Related Institution

School of Mechanical & Electronic Engineering, Henan University of Science & Technology

Qingdao Choho Industrial Co.，Ltd.

School of Mechanical and Vehicle Engineering， Changchun University

Engineering Research Center of Chemical Safety Ministry of Education， Beijing University of Chemical Technology

Machinery and Equipment Advanced Manufacturing Cooperative Innovation Center of Henan Province

⁰