Analysis and Experimental Investigation of Oil Jet Flow of Main Reducer Gear based on Flowmaster

Yin Zhimin; Liu Shaojun

doi:10.16578/j.issn.1004.2539.2017.01.018

您当前的位置：

首页 >

文章列表页 >

Analysis and Experimental Investigation of Oil Jet Flow of Main Reducer Gear based on Flowmaster

更新时间：2022-10-20

- Analysis and Experimental Investigation of Oil Jet Flow of Main Reducer Gear based on Flowmaster
- Vol. 41, Issue 1, Pages: 82-86(2017)
- 作者机构：
  
  1. 中南大学机电工程学院
  2. 中南大学高性能复杂制造国家重点实验室
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.2017.01.018
  CLC：
扫描看全文
[1]尹志敏,刘少军.基于Flowmaster的主减速器齿轮喷射流量分析与试验研究[J].机械传动,2017,41(01):82-86.

Yin Zhimin, Liu Shaojun. Analysis and Experimental Investigation of Oil Jet Flow of Main Reducer Gear based on Flowmaster. [J]. 41(1):82-86(2017)
[1]尹志敏,刘少军.基于Flowmaster的主减速器齿轮喷射流量分析与试验研究[J].机械传动,2017,41(01):82-86. DOI： 10.16578/j.issn.1004.2539.2017.01.018.

Yin Zhimin, Liu Shaojun. Analysis and Experimental Investigation of Oil Jet Flow of Main Reducer Gear based on Flowmaster. [J]. 41(1):82-86(2017) DOI： 10.16578/j.issn.1004.2539.2017.01.018.

摘要

针对某型主减速器润滑系统中的喷嘴喷射影响,采用一维流体仿真软件Flowmaster软件仿真方法,提出较全面和准确的分析模型。并利用Flowmaster软件建立某型直升机主减速器润滑系统喷嘴的仿真模型,分别以0.35 MPa和0.40 MPa的供油压力为单一变量对模型进仿真研究,然后,对仿真模拟的结果与试验结果进行了对比分析,验证该仿真方法和模拟的有效性与准确性。

Abstract

The influence on oil jet flow in nozzle of lubrication system for the main reducer is researched based on the one- dimensional Flowmaster fluid simulation,a more comprehensive and accurate analysis model is put forward. By using the Flowmaster software,the simulation model of oil jet of the main transmission lubrication system is built. Taking the oil pressure 0. 35 MPa and 0. 40 MPa as a single- variable to study the model. Then the simulation and the experimental results are compared and analyzed,the validity and accuracy of the calculation method and model are verified.

关键词

主减速器润滑系统喷嘴仿真研究

Keywords

Main reducerLubrication systemOil jetSimulation study

references

Views

123

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research of High Temperature Problem of High-speed Shaft Bearing for MW-class Wind Power Increase Gearbox

Design and Research of Energy Supplement System for Ocean Buoy

Design and Experimental Research of Lubrication System of High Power Transfer Case

Research of the Pressure Angle Optimization of Main Reducer Gear based on ADAMS

Dynamic Performance Analysis of UAV Main Reducer

Related Author

No data

Related Institution

Xuchang XJ Wind Power Technology Co.， Ltd.

Hubei Key Laboratory of Hydroelectric Machinery Design & Maintenance， China Three Gorges University

College of Mechanical and Power Engineering， China Three Gorges University

Rocket Force Military Representative Office in Jinan Area

Beijing Institute of Space Launch Technology

⁰