Comments on K<sub>Hβ</sub> in ISO6336 and its approach

Li Zbaogang

doi:10.16578/j.issn.1004.2539.1994.03.007

您当前的位置：

首页 >

文章列表页 >

Comments on K_Hβ in ISO6336 and its approach

更新时间：2025-04-03

- Comments on K_Hβ in ISO6336 and its approach
- Issue 3, (1994)
- 作者机构：
  
  南京高速齿轮箱厂
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.1994.03.007
  CLC： TB93
- Published：1994
- 稿件说明：
移动端阅览
[1]李钊刚.再谈ISO的K_（Hβ）计算中的问题及解决办法[J].机械传动,1994(03):21-23+57.

Li Zbaogang. Comments on K_Hβ in ISO6336 and its approach[J]. 1994, (3).
[1]李钊刚.再谈ISO的K_（Hβ）计算中的问题及解决办法[J].机械传动,1994(03):21-23+57. DOI： 10.16578/j.issn.1004.2539.1994.03.007.

Li Zbaogang. Comments on K_Hβ in ISO6336 and its approach[J]. 1994, (3). DOI： 10.16578/j.issn.1004.2539.1994.03.007.

摘要

本文通过分析和大量计算，指出ＩＳＯ的ＫＨβ公式，未反映空载时接触理论长度ｂｃｏ对齿向载荷分布的影响；提出了ＫＨβ的修正公式。实践证明修正公式计算结果是比较符合实际的。

Abstract

Based on analyses and a lot of calculations

it is pointed out in this paper that the error of ISO formula Keg on longitudinal load distribu tion in which without taking account of the effect for contact pattern length boo under no load on the teeth

and the revised formula was provided.More reasonable results of calculation by revised formula are approved on field applications.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

斜齿轮接触线上载荷分布的弹流润滑解

Research on K_Hβ-C1 of ISO6336

Research on Face Load Distribution for Narrow Helioal Gears

Study of Load Distribution Along the Contact Lines of Cylindrical Gears

How to Use the Eccentric Bush to Adjust the Contact Pattern for Cylindrical Gears

Related Author

于同辉

陈谌闻

李钊刚

刘建国

王宪法

Li Janfeng

et al.

王寿佑

Related Institution

哈尔滨工业大学

山东工业大学

太原矿山机器厂

⁰

Comments on KHβ in ISO6336 and its approach

DOI：10.16578/j.issn.1004.2539.1994.03.007

摘要

Abstract

关键词

Keywords

references

Comments on K_Hβ in ISO6336 and its approach