Tooth Contact Analysis of Internal Spiral Bevel Gears Cut by Full Formate Method

您当前的位置：

首页 >

文章列表页 >

更新时间：2025-04-03

- Tooth Contact Analysis of Internal Spiral Bevel Gears Cut by Full Formate Method
- Issue 2, (1994)
- 作者机构：
  
  西安交通大学
- 作者简介：
- 基金信息：
- DOI：10.16578/j.issn.1004.2539.1994.02.002
  CLC： TH132.416
- Published：1994
- 稿件说明：
移动端阅览
[1]霍荆平,毛世民,吴序堂.用全成形法加工的内啮合弧齿锥齿轮的齿面接触分析[J].机械传动,1994(02):4-9+13+63.

IIuo Jingping, et al.. Tooth Contact Analysis of Internal Spiral Bevel Gears Cut by Full Formate Method[J]. 1994, (2).
[1]霍荆平,毛世民,吴序堂.用全成形法加工的内啮合弧齿锥齿轮的齿面接触分析[J].机械传动,1994(02):4-9+13+63. DOI： 10.16578/j.issn.1004.2539.1994.02.002.

IIuo Jingping, et al.. Tooth Contact Analysis of Internal Spiral Bevel Gears Cut by Full Formate Method[J]. 1994, (2). DOI： 10.16578/j.issn.1004.2539.1994.02.002.

使用全成形法加工内啮合弧齿锥齿轮与展成法相比有许多优点。本文给出了用这种方法加工的齿轮副的齿面方程和求解接触点的方法，推导了在任意接触点处的二阶分析公式以及在参考点啮合时的三阶分析公式，并讨论了分析的结果。

Comapared with the gencrating mothed

the fall formate method is with many merits in cutting internal spiral level spiral level gears

In this paper

the tooth surrace equations and calculative procedure of contact points are given of the internal spiral level gears cut by the full formate method

the second-order analysis for mulae at any contact pount and the third-order analysis fromulac at reference point are devcloped

the analysis results are also discussed.

Views

131

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

⁰